Here is my submission to the on going issue of not being able to fit standard panniers to the rear of a Rad Runner using existing fixing points:
?300mm long 15mm dia anodised aluminium DSLR camera rails (with heat shrink tubing) - ?15
?15mm dia, 12.5mm tall black nylon saddle risers
?15mm dia stainless steel, rubber lined cable P Clips (suggested from a post on this forum) - ?5 for 5
?50mm M6 hex bolts with their ends covered by domed nut covers
The heat shrink tubing takes the rails to 16mm which is the largest size that third party standard panniers cater to, that I could find.
It's the simplest and neatest solution I could find - hope it's useful to someone!
?300mm long 15mm dia anodised aluminium DSLR camera rails (with heat shrink tubing) - ?15
?15mm dia, 12.5mm tall black nylon saddle risers
?15mm dia stainless steel, rubber lined cable P Clips (suggested from a post on this forum) - ?5 for 5
?50mm M6 hex bolts with their ends covered by domed nut covers
The heat shrink tubing takes the rails to 16mm which is the largest size that third party standard panniers cater to, that I could find.
It's the simplest and neatest solution I could find - hope it's useful to someone!