The buttons on my Remote UI component are sticking. The bike is about 2 ? years old so I'm hoping it just needs to be blown (cleared) out with some contact spray (essentially canned air).
While there's lots of info on-line about the main display there seems to be very little on the remote.
Does anyone have any experience, suggestions, YouTube clips addressing this issue?
Can I safely pry the cover off of the remote, clean it out and put the cover back on without disturbing the electronics inside ? Any would be welcome and appreciated. Thanks in advance
Sent from my motorola edge plus 5G UW (2022) using Tapatalk
While there's lots of info on-line about the main display there seems to be very little on the remote.
Does anyone have any experience, suggestions, YouTube clips addressing this issue?
Can I safely pry the cover off of the remote, clean it out and put the cover back on without disturbing the electronics inside ? Any would be welcome and appreciated. Thanks in advance
Sent from my motorola edge plus 5G UW (2022) using Tapatalk