Hi all.
I have a new replacement 750W controller fitted to my Rad Rhino 5 delivered direct from RAD and fitted by a service partner.
My previous controller gave a steady 750W on the display when set at PAS 5 or full throttle and a fully charged battery.
The new controller only gives a max of 600W. It?s not an error in the display as it feels less drive than the 750W so I believe its correct. Full battery and clean terminals. PAS level 5 or throttle is the same.
Is there a hidden menu that I can access that might get it back to 750W?
Any help appreciated.
Thanks
I have a new replacement 750W controller fitted to my Rad Rhino 5 delivered direct from RAD and fitted by a service partner.
My previous controller gave a steady 750W on the display when set at PAS 5 or full throttle and a fully charged battery.
The new controller only gives a max of 600W. It?s not an error in the display as it feels less drive than the 750W so I believe its correct. Full battery and clean terminals. PAS level 5 or throttle is the same.
Is there a hidden menu that I can access that might get it back to 750W?
Any help appreciated.
Thanks