Hi All,
I'm new to posting to the forum but been lurking for sometime.
I purchased the Bolton controller about 8 months ago and just installed it about a week ago.
I am getting the motor not detected error.
Are there specific settings that would cause this error or that I could change to test?
Has anyone been successful in installing it in the Rad Wagon 1 and what steps did you take?
Currently because the new display connector is different from the old harness I hardwired the display matching the wire colors. I would assume tx/rx communicate is over 2 of the wires power/gnd on 2 not sure what the 5th wire is for.
I'm new to posting to the forum but been lurking for sometime.
I purchased the Bolton controller about 8 months ago and just installed it about a week ago.
I am getting the motor not detected error.
Are there specific settings that would cause this error or that I could change to test?
Has anyone been successful in installing it in the Rad Wagon 1 and what steps did you take?
Currently because the new display connector is different from the old harness I hardwired the display matching the wire colors. I would assume tx/rx communicate is over 2 of the wires power/gnd on 2 not sure what the 5th wire is for.