Battery Terminal Cover

[jimu]

Hi, Canadian owner here. Anyone know where to buy a terminal cover for the Rover 6? As an alternative a file number for a 3D printer would work as well.
Thanks

[Si1Dia]

Blue painter's tape works great for me, to cover the connector side of the battery.

[jimu]

What I'm looking for is the cap to cover battery connection on the frame. Apparently this should be covered when transporting on a hitch rack. I'm also wondering if some dielectric grease would be an alternative solution.

[crorris]

On my Rover 5 I took a large plastic bag and wrapped it around the entire battery mount and frame a few times. Then I secured it with long velcro straps above and below the battery mount. I did the same thing with the controller and display. I drove with it on my hitch rack for 3000 miles like this through some heavy rain storms for part of that. It worked well and kept things dry. I considered using a full cover as well (like for a motorcycle), but just went this route instead.

[Altema]

Rad sells the terminal cover here:
https://bit.ly/3cX3aUw

I found a few Rad terminal 3D files, but none for your model.

[lucdrb]

I've made a 3D model for myself.

I can share it with you

Luc

[lucdrb]

I've Publish the 3D file on my cults3D account.

https://cults3d.com/fr/mod%C3%A8le-3d/divers/couvre-connecteur-rad-6

This piece suit my needs if you have any comments feel free to sent it

Luc

[JedidiahStolzfus]

I printed this one from Thingiverse.
https://www.thingiverse.com/thing:4911927

I modified this one to be just a solid piece and to make it fit a little more snug.
https://www.thingiverse.com/thing:4898117